Bit-perfect ASIO drivers to solve issues with Windows audio quality

By default, Windows audio quality can be technically not superb. ASIO drivers or similar can improve audio output significantly by bypassing Windows resampling and other audio processing stages. This post is a consequence of testing the USB-input of H-DAC. Its PCM2707C-circuit is capable of “only” 48 kHz / 16-bit audio so I was not expecting superb measurement results but was still amazed how bad they actually are. This is purely technical … Continue reading

Understanding audio measurements: Crosstalk

Expresses “leaking” between channels; it is measured by driving a stimulus signal in one channel while listening the other. Crosstalk is expressed as a ratio between the quiet undriven channel and the stimulus in the driven channel, and given in decibels. In stereo system, crosstalk is measured by driving a stimulus signal in one channel while listening the other. As the signal level is very small, sharp bandpass filter is … Continue reading

Understanding audio measurements: THD+N vs. amplitude and frequency

Presents the unwanted part of the signal – something that was not put there and should not be there. THD+N vs. amplitude graph is important as it reveals SNR, dynamic range, and THD+N ratio; all are expressed as ratio compared to a specified signal level. Signal level, signal frequency, and measurement bandwidth must be known (or guessed) when analysing results. THD+N, Total Harmonic Distortion plus Noise, is one of the best audio … Continue reading

Understanding audio measurements: noise, SNR, and dynamic range

SNR is a ratio of level measurement and noise measurement (both typically as RMS level), expressed in dB. Signal level, measurement bandwidth, and weighting filter must be defined. Dynamic range is like SNR but noise is measured in the presence of small signal; results should be the same. Noise is one of the most important performance figures and typically compared to the signal level as SNR, Signal-to-Noise Ratio. In audio … Continue reading

Understanding DAC filters and their impact in time and frequency domains

Many DAC chips and devices using those chip have user selectable options for digital filter response to fine-tune tonal characteristics. I will take PCM1794A used on H-DAC as an example and see what effects these filter types have on impulse and frequency responses. This is just scratching the surface of the topic by briefly introducing some technical effects that can be measured. Tonal characteristics are not discussed here; those are highly subjective … Continue reading